Base Station Subsystem Details, Meaning Base Station Subsystem Article and Explanation Guide

Base Station Subsystem Guide, Meaning , Facts, Information and Description

The Base Station Subsystem (BSS) is the section of a GSM network which is responsible for transmitting to and receiving radio signals from the mobile phone. The BSS carries out transcoding of speech channels, allocation of radio channels to mobile phones, paging and many other tasks related to the radio network.

Table of contents

1 Base Transceiver Station

1.1 Sectorisation

2 Base Station Controller
3 Transcoder
4 Packet Control Unit

Base Transceiver Station

The Base Transceiver Station or BTS is the actual transmitter and receiver of radio signals. Typically a BTS for anything other than a pico cell will have several different transceivers (TRXs) which allow it to serve several different frequencies or even several different cells (in the case of sectorised base station).

Sectorisation

By using directional antennae on a base station, each pointing in different directions, it is possible to sectorise the base station so that several different cells are served from the same location. This increases the traffic capacity of the base station (each frequency can carry eight voice channels) whilst not greatly increasing the interference caused to neighboring cells (in any given direction, only a small number of frequencies are being broadcast).

Base Station Controller

The Base Station Controller (BSC) provides the intelligence behind the BTSs. Typically a BSC has 10s or even 100s of BTSs under its control. The BSC handles allocation of radio channels, receives measurements from the mobile phones, controls handovers from BTS to BTS (except in the case of an inter-MSC handover in which case control is in part the responsibility of the Anchor MSC). A key function of the BSC is to act as a concentrator where many different low capacity connections to BTSs (with relatively low utilisation) become reduced to a smaller number of connections towards the MSC (with a high level of utilisation). Overall, this means that networks are often structured to have many BSCs distributed into regions near their BTSs which are then connected to large centralised MSC sites.

Transcoder

The Transcoder (TCU) is not fully specified as part of the standard, being closely linked to the BSC. This subsystem is also referred to as the TRAU (Transcoder and Rate Adaptation Unit). The transcoding function converts the voice channel coding between the GSM (Regular Pulse Excited-Linear Predictive a.k.a RPE-LPC) coder and the CCITT standard PCM (G.711 A-law or u-law). Since the PCM coding is 64 kb/sec and the GSM coding is 13 kb/sec, this also involves a rate adaption function to compress voice channels from the 64kb/sec PCM standard to the 13kb/sec rate used on the air interface. Some networks use 32 kb/sec ADPCM on the terrestrial side of the network instead of 64 kb/sec PCM and the TRAU converts accordingly.

However, at least in Siemens, and Nokia's architecture this is an identifiable separate system which will normally be co-located with the MSC and in some of Ericsson's systems it is integrated to the MSC rather than the BSC. The reason for these designs is that if the compression of voice channels is done at the site of the MSC, transmission costs can be reduced.

Packet Control Unit

The Packet Control Unit (PCU) is a late addition to the GSM standard. It does some of the equivalent tasks of the BSC, but for packet data. The allocation of channels between voice and data is controlled by the base station, but once a channel is allocated to the PCU, the PCU takes full control over that channel.

The PCU can be built into the base station, built into the BSC or even, in some proposed architectures, it can be at the SGSN site.

This is an Article on Base Station Subsystem. Page Contains Information, Facts Details or Explanation Guide About Base Station Subsystem